Need the following early round fog light parts:
- Retaining clips that secures the lens/bulb/reflector/trim ring assembly to housing
- Mounting brackets with dish washers, bolt and washer
Would like to buy several if available - Thanks
"Help me Obi Wan, your my only hope."
I can probably spare a few pairs of conical washers. I can get the brackets made up new. Can do them in steel and zinc plate them or go with stainless steel. How many would you need ?
Thanks Bruce - PM sent.
Anyone have the small retaining clip that secures the lens assembly to the housing that they can spare? Only parts I need to complete a fog light restoration - thanks.
"Help me Obi Wan, your my only hope."
All the Fog lights and parts I have..
Pm for negotiation.
I'have no use or Time to deal with em.
PM sent - thanks
We have started manufacturing new springs.
.99 each
https://shop.914rubber.com/Fog-Light-Tension-Spring-OEM91463192410.htm?categoryId=-1
Attached thumbnail(s)
Also make new seals and have lenses in several flavors. The lens looks a little weird as it has the glass protector installed on it. And yes we sell those too.
https://shop.914rubber.com/914-Fog-light-gaskets-set-of-2-enough-for-one-car-914FLG.htm?categoryId=-1
Attached thumbnail(s)
[quote name='Mikey914' date='Jun 10 2018, 11:23 PM' post='2618270']
Also make new seals and have lenses in several flavors. The lens looks a little weird as it has the glass protector installed on it. And yes we sell those too.
That great, but what about the clip that he asked for originally ?
Bruce
Bruce,
Thanks for mentioning our need for the other retaining clip.
Unfortunately, someone hijacked this thread and bought "majkos1'S" stash of "previously tested" parts before I responded and send a PM.
Win so, lose some.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)