Printable Version of Topic

Posted by: Pdr1787 May 2 2018, 02:05 PM

I might be selling some wiring not sure yet (with plugs) but this is what I'm willing to let go of or don't need. Also willing to negotiate.

Tail shift Linkage (allparts to firewall) 80
Tail shift Transmission 250
Tail shift cover (trans and firewall) 40
Tail shift Motor mount Brace and crossmember 50
1.7l heat exchangers 150
Passenger side heater control valve and elbow to heat exchanger. 60
Side shift linkage to transmission. 200
2 Solex 31 Carbs. probably should be rebuilt and Intake Manifolds 50 Sold
12 volt Bosh coil used for only 300 miles 40
2 Voltage regulators 100 for both
Bosh original distributor with vacuum 50
Mechanical advance distributor chrome 009 80
1.7l rods 80 for 4
2.0l type 4 cylinders 80
Heater fan blower 80
8' passenger footwell sub and box. 100 SOLD
original speaker grills 40
1.7l ecu 120
intake and exhaust valves/ high rev double springs (new) for 2.0l porsche heads. 150 SOLD

Posted by: jtprettyman May 2 2018, 02:33 PM

I'm in for the carbs and manifolds! PM coming.

Posted by: Jeff Bowlsby May 2 2018, 07:04 PM

Exactly what wiring?

Posted by: Jeff Bowlsby May 2 2018, 07:05 PM

Exactly what wiring?

Posted by: Pdr1787 May 2 2018, 07:35 PM

The wiring harness that comes out of the firewall and goes to the voltage regulator and what not

Posted by: mxkinn01 May 2 2018, 07:46 PM

How about pictures of the speaker grills? If they are in good shape I'll take them.

Posted by: Pdr1787 May 3 2018, 04:19 PM

Here is the subwoofer and speaker grills


Attached thumbnail(s)

Posted by: mxkinn01 May 3 2018, 07:11 PM

Thank you for the pictures of the speaker grills. I will pass, as mine are in better shape.
Thanks
Mike

Posted by: Jeff Bowlsby May 3 2018, 07:30 PM

That’s a small potion of the main chassis harness. It’s not a separate harness. Don’t cut any wiring, just remove it in one piece and sell it complete.

Posted by: Driver174 May 3 2018, 11:18 PM

2.0l type 4 cylinders 80

What brand of cylinders? and how much for four shipped to 89119?

Thanks,

Posted by: Pdr1787 May 10 2018, 03:10 PM

Do you have any tips on wire harness removal before I pull it out?

Posted by: Jeff Bowlsby May 11 2018, 05:01 PM

Don't cut anything.

Remove the plastic connectors/covers where needed - 14pin, headlights, etc.

Don't cut anything.

Use non-oil based lube if needed in the center tunnel - KY jelly.

Don't cut anything.

Posted by: Pdr1787 May 12 2018, 11:01 PM

Transmission picture


Attached thumbnail(s)