Printable Version of Topic

Posted by: ClayPerrine Jun 6 2018, 05:17 PM

All...

I am looking to buy the fuel pump wire from a 75 (or 76) 914. It is black with a red stripe and runs from the relay board in the engine compartment to the left side of the car under the gas tank. I want my DME in my 4.0 to have the correct wiring color codes. This is the one I don't have.

If you have a junk harness from a 75, I would like to purchase the fuel pump wire.

Thanks!

Posted by: tweet Jun 6 2018, 05:21 PM

If you don't find it here, Jeff Bowlsby may be able to make it for you. He specializes in wiring. He also has his own site:
http://bowlsby.net/914/WiringHarnesses/

Posted by: 914Sixer Jun 6 2018, 06:11 PM

Clay,
Left me see what I have in the warehouse. I have a couple of harnesses.

Posted by: Luke M Jun 7 2018, 07:28 AM

Hi Clay,

Check this site out.
Way better then a 42 + y/o wire.

https://4rcustomswire.com/

Posted by: Jeff Bowlsby Jun 7 2018, 08:12 AM

You need 12 gage black/red stripe and 12 gage brown for the ground. I don’t stock it.

Posted by: John Jentz Jun 7 2018, 09:06 AM

I got that color code (Black/red stripe) at NAPA. Was 14 ga , works fine.

Posted by: Jeff Bowlsby Jun 7 2018, 09:13 AM

14 ga may work, but is undersized...per the factory schematic.

Posted by: 914Sixer Jun 7 2018, 01:27 PM

My harness was cut in two pieces. It is solid red though.

Posted by: Jeff Bowlsby Jun 7 2018, 06:17 PM

Solid red is direct battery power from the battery to the relay board and or ignition switch depending on year. The fuel pump circuit is black/red on all 914s.

Posted by: cary Jun 8 2018, 09:00 AM

https://www.sherco-auto.com/striped-tinned-tracer-primary-wire-14-ga-x-25-ft-black-wred-stripe-25-ft-usa-made-for-marine-and-automotive-use-also-in-25-ft-rolls.html

http://www.riwire.com/

Posted by: ClayPerrine Jun 8 2018, 05:31 PM

I already have the ground taken care of. The fuel pump for the MFI is already up front. I just need to go from the DME relay in the engine compartment to just above the relay board where the current fuel pump wire terminates.

I would like to have a factory wire.

Clay