I am looking to track down one of the engine mount washer plates that go on top of the carrier. One of mine is completely trashed and I don't feel good re-using it. I've highlighted the piece below, shoot me a PM if you have one.
Thanks
I think i have one in my cut-out pile. Let me go check
I have one, I am getting new ones from Bruce Stone. 914 rubber sells them too.
I have this used piece that was replated (looks new)...Make me an offer!
Attached thumbnail(s)
If you can't find the factory part, you can always use a 911 solid transmission mount like these...
You can also use some steel flat bar and drill 3 holes.
All set thanks to Travis
Appreciate all of the offers. Thanks everyone
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)