Includes the front and rear backing plates pictured.
$100 plus shipping and paypal fees.
In response to questions asked,
The caliper bolt holes are 3 inches center to center.
The rotors are about 3/4 inches thick with slight ridges
The rotor diameter is 11 1/2 inches.
Further inspection suggests the calipers have not been rebuilt.
That's a great deal
Is this something that can be used on a stock '74 914?
They will bolt up to the rear of the a stock 914. You need to run vented 911 discs. You might be able to remove the spacers in the pads and run stock rotors. Idk for for sure. But you would then need to upgrade your front brakes to correct the front to rear balance and you would have no e brake.
I'll take them.
PM sent.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)