My door panel vinyl is flopping around at the top, the cardboard thickened piece or whatever broke apart.
Thanks!
Paul
Thanks Steve. I think the local upholstery place can tuck it up again or even get the 914 rubber panel for a rebuild. But I was hoping to go the easy way out and get one that's already done. So all the fabric is already there, just needs the "tuck."
I remember how excited you were to find that George had a 1971 new interior for your M471 build.
Great to hear from you!
Paul
I have a feeling this could easily be fixed. I suspect the issue is the part that tucks over the card noard came loose.
If you can post up some pics we can see for sure.
OK, Mikey aka Mark, some pics.
The upper middle portion is loose, it is no longer tucked underneath.
Pulling up reveals the sagging a bit better. The previous picture showed how tight the vinyl is up by the side mirror.
I am pinching the ?cardboard? in between my fingers in this picture. It is like a broken piece floating under the baggy vinyl. I can move it around between my fingers.
A long shot and closer up demonstrating (I hope) how the vinyl is properly tucked near the front of the door. Whatever you see in this pic is way, way worse flapping in the breeze!
Hope this helps. Still looking for the door card!
Paul
I would take it to an upholsterer and have them fix it.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)