I'm hanging the inside front wheel a little bit more than I want to and have a bit of roll-over oversteer in the rear. I'm looking to ideally work a trade, but I'm happy to buy outright too (remember, these are only $65 new, yes I am that cheap).
I currently have a 2.5" ID, 225lb, 8" spring. I'm looking for a 7"-8" spring between 250-300lbs.
This is a reference pic of a 150lb spring I used to run, this is why I think it is 10" tall for the 250lb set
Attached image(s)
Thanks, Travis! Unfortunately my threaded perches are such that even an 8" is technically too long.
Alright..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)