Hey everyone. I need the following parts to finish this DD project.
Stock 1.8L muffler.
Factory door stop
E-brake pin
Flywheel dowel pins that evidently went MIA after machining.
Heater flapper on heat exchanger barrel nut for the control wire.
Possible an L-jet AAR if I can't get this one working.
Harness relay board to engine. I'm missing the relay connector & attached wires.
Pics, just because...
Which side door check?
Is this the harness that you need:
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)