looking for manifold and water pump.
thanks
jim
Attached image(s)
https://daviescraig.com.au/category/ewp-header-adaptors
Available from Summit
no need to source antiques any longer.
I've run their pumps for years without any issues.
i think i'll go with the dedenbear manifold cause its metal and seems to protrude less from engine than anything else.
though i do like the davies pump with its 1" npt female threads and its price. what i am not sure of is if 30 gpm is enough? and how important is their pump controller which i very much would prefer to NOT need.
i did pick this up for $40 the other day.
Attached thumbnail(s)
Attached image(s)
https://www.amazon.com/Dedenbear-Products-WH1-Water-Header/dp/B003NEIJWG
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)