Work was done by a professional shop in Phoenix, AZ. Distributor was taken apart and cleaned by ultrasonic. Fiber washers replaced. All springs and weights checked and lubricated. NOS points plate with new points installed and trigger points checked. New Bosch limiter rotor, cover plate, condensor and cap installed. Distributor was then put on a Sun Distributor Machine and tested to make sure the curve was correct. Replated clamp included. Good as new. 039 905 205A $249 shipped
Paypal: a914nut@email.com
Attached image(s)
Need it gone. Price reduction to $249.
Is this the 205A or 205B Mark?
039 905 205A
Yes, it did.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)