I see Engman used to make these, does anyone have a set lying around or a decent copy?
pretty sure I do. Let me check
Dylan - If you can't find any, I have a '75 and could do a quick measure and cut you a set on the plasma table. You want steel or aluminum?
Seriously, let me know if I can help. You pay shipping only.
I could use a set for my 75 too, Doing bumper conversion this week. Thin steel would work for me. Be happy to pay.
Hate to say it... but I could use a set too. Would also pay.
I have a few pairs bring made locally, what ever I don't use will be available.
guess i’ll need a set too
I’d be up for some too...
me too!
Me too
I'm not a great fabricator, but covering those holes was pretty simple. I just cut some sheet aluminum I had laying around and drilled two holes. They don't show with the bumper on so they don't even have to look good. About 15 minutes. Probably the easiest part of the bumper conversion.
Ok, I've for 13 pairs made.
$15 shipped per pair
Alright please send PayPal info and I will pm shipping address
I will take a set. I will shoot you a PP on request.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)