Want to buy two hydraulic brake parts as pictured.
The first attaches to the master cylinder, the second to the brake pressure relief valve.
Would also be interested in an early screw attached muffler heat pan.
Attached thumbnail(s)
I have the T for the pressure regulator. I have a 70 parts car that has the heat shield but I’m unsure about condition, I think I have the MC part but not 100% sure. All yours for free. I can check on the heat shield tomorrow.
I have both fittings
Rory are you after the early round shield or a late one? I have a later one https://914werke.com/shop?keywords=shield&olsPage=products%2Fmuffler-heat-shield
I think this is what you want. The only caveat is I can’t get to it for a couple weeks. I’m having some neck surgery done and dr says no heave lifting for a while. The engine has to come out first but it’s yours if you want it.
@http://www.914world.com/bbs2/index.php?showuser=5176
Attached thumbnail(s)
Attached image(s)
I found the correct fitting.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)