These are reproduction brackets made of slightly thicker material for added strength. The center hole attaches the bolt to engine bar for the side shift type to the body. The end hole take the 8mm bolts to the body mount console.
I have four powder coated sets ready. 8mm bolts are not pictured but are included. Have a few more sets that are going in for gold zinc plating. Ready in about a week. Gold is the original finish but does not last well in that area. Powder coating is much better. zinc done at this time.
Most are badly bent from lifting the car form the engine bar. I had these reproduced out of thicker steel and powder coated. $35 per pair shipped. I have 6 sets available.
Includes: (2) New 10mm bolts,washers and serrated flange nuts
(4) 8mm bolts, washers and serrated flange nuts for better holding.
Nuts and washers are stainless steel to resist corrosion.
Serrated flange nuts provide better holding.
$40 a pair shipped
Paypal accepted
NO FRIENDS and FAMILY!
Bruce
Attached thumbnail(s)
Bump, Have a new batch in powder coat or yellow zinc.
Hi Bruce, 1 pair powder coated for me pls.
1 pair powdercoated please, Bruce
Hi Bruce, just checking if you already ship the items? thank you!
@http://www.914world.com/bbs2/index.php?showuser=13474
' date='Jul 25 2020, 01:21 PM' post='2837049']
Hi Bruce, just checking if you already ship the items? thank you!
They will go out monday. I ran out of black and the powder coater just got rhem gone yesterday.
Sorry for the delay
Hi Bruce, just checking any update of the engine bracket for me.
Well maybe you are just so busy and forgot to ship mine.
Stay safe!
I'll take a set in black powder coat.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)