This small spring holds the lower part of the fog light to the upper part so that the faces do not fall off.
Looking very disparately, would appreciate if you have them nd willing to sell. Need a bunch for a project. Comes 2 to a set and is screwed in the lower body.
Appreciate any info.
These?
https://900designs-container.zoeysite.com/fog-light-tension-spring-1
@http://www.914world.com/bbs2/index.php?showuser=5910
@http://www.914world.com/bbs2/index.php?showuser=21628
These?
https://900designs-container.zoeysite.com/fog-light-tension-spring-1
[/quote]
No.
thanks. The part i outside of the lamp held buy a screw and just above the connecting assembly bolts and all. Thanks.
[/quote]
No one is making them to my knowledge. I could use a bunch. I somehow lost about 20 of them. It is a spring steel part and tricky to make.
I have a few
They are likely "spring" steel. 914 Rubber should get these made up.
Drop me a pic here.
Is the the one that the screw holds the ring on?
If so yes we can do them, but may be about 6-8 weeks on our current schedule.
-Mark
@http://www.914world.com/bbs2/index.php?showuser=3348
Drop me a pic here.
Is the the one that the screw holds the ring on?
If so yes we can do them, but may be about 6-8 weeks on our current schedule.
-Mark
[/quote]
Yes Mark, That is the one. You have looked at them before and correctly noted that some of them have a square hole of unknown purpose.
I think the thread is on this board. I could use 20 of them as I lost that may and have fogs I cant complete.
Bruce
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)