Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ WTB Original Carpet Pieces

Posted by: aturboman Sep 9 2019, 09:14 AM

I'm looking for original Perlon carpets for drivers floor and passenger sill.

Must be original factory and in good condition, typically these were used in 1970-72 cars.

Please let me know what you have in your garages and basements.

Thanks

Posted by: Tom_T Sep 9 2019, 10:33 AM

QUOTE(aturboman @ Sep 9 2019, 08:14 AM) *

I'm looking for original Perlon carpets for drivers floor and passenger sill.

Must be original factory and in good condition, typically these were used in 1970-72 cars.

Please let me know what you have in your garages and basements.

Thanks


Your best bet AFAIK would be to contact George Hussey at Auto Atlanta directly, since he has a stash of NOS carpet pieces, but they're not cheap.

I had to go that route for mine because nobody makes anything close to my 73's Dar Tan Lop Pile carpet, & he was very helpful.

If he doesn't have all the pieces you need, ask if he has any of the NOS roll stock to make you some, &/or using other pieces to re-cut to the ones you need, as he also has the edge binding materials too.

Good Luck! beerchug.gif
Tom
///////

Posted by: aturboman Sep 9 2019, 02:07 PM

Thanks Tom for the good input.

This is a driver quality car and the rest of the carpets are decent but NOS would be too nice.

Hopefully they'll turn up.

QUOTE(Tom_T @ Sep 9 2019, 09:33 AM) *

QUOTE(aturboman @ Sep 9 2019, 08:14 AM) *

I'm looking for original Perlon carpets for drivers floor and passenger sill.

Must be original factory and in good condition, typically these were used in 1970-72 cars.

Please let me know what you have in your garages and basements.

Thanks


Your best bet AFAIK would be to contact George Hussey at Auto Atlanta directly, since he has a stash of NOS carpet pieces, but they're not cheap.

I had to go that route for mine because nobody makes anything close to my 73's Dar Tan Lop Pile carpet, & he was very helpful.

If he doesn't have all the pieces you need, ask if he has any of the NOS roll stock to make you some, &/or using other pieces to re-cut to the ones you need, as he also has the edge binding materials too.

Good Luck! beerchug.gif
Tom
///////


Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)