Just got my Blaupunkt Frankfurt refurbished. Some of the parts I had that came to me when I bought the (broken) radio were a super thick basketweave faceplate. This thing is super stout but I think if I mount the radio to it it will stand proud of the remaining basketweave trim on the dash. So I’m looking for:
1. The large faceplate that the dial indicator and knobs would ‘stick through’.
2. Side clips for the radio. The correct type allow the radio to snap/clip into the hole in the main metal dash.
3. A ‘U’ clip. This clip attaches to the back of the radio (via the ‘U’) and has two small tabs that attach to the bulkhead just behind the radio. So the clip essentially hold up the back portion of the radio.
4. Possibly the small chrome bezel that fits around the dial indicator area.
Need picture of radio to be installed. All kinds of different holes. Yes, 90% of all dash plates are the WRONG thickness and DO stick up. Chrome nose pieces are expensive. U mounting clips are getting scarce.
This is what’s going in. The plate is really thick (and one of the knob holes is slightly off).
Attached thumbnail(s)
Ok, let me look. I think I have a used Blaupunkt factory dash plate. I would repaint the Blaupunkt face plate you have. Chrome nose pieces go from $75 to $150 depending on where you shop. Picture later.
Factory Blaupunkt big knob plate. What's your shipping info, will send it to make sure it will work.
Attached image(s)
For radio installation kits and other goodies, check out Konigs-Klassik-Radios in Germany.
Konigs-Klassik-Radios also carries the correct speakers for 914s.
I have a set side clips available
http://www.early911sregistry.org/forums/showthread.php?148263-FS-Clips-for-Blaupunkt-Radio
I’ll take those clips!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)