Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ Sold - Replated Pushrod Tube Set with Viton O rings $80 shipped

Posted by: bdstone914 Nov 30 2019, 10:19 AM

SOLD

This is a set of the later, larger diameter pushrod tubes that were cleaned and replated. New Viton o rings were installed. Some small dents.

Will fit all Type IV except early 1.7L heads with smaller holes.

$80 for the set shipped USPS Priority mail in the U.S.

Paypal to bdstone914@aol.com

Bruce

Attached thumbnail(s)

Posted by: 6s219 Nov 30 2019, 06:20 PM

QUOTE(bdstone914 @ Nov 30 2019, 08:19 AM)

This is a set of the later, larger diameter pushrod tubes that were cleaned and replated. New Viton o rings were installed. Some small dents.

Will fit all Type IV except early 1.7L heads with smaller holes.

$80 for the set shipped USPS Priority mail in the U.S.

Paypal to bdstone914@aol.com

Bruce

If these will work with a 1974 2.0, I’ll take them.

Posted by: bdstone914 Nov 30 2019, 09:09 PM

@26s219
Paypal to bdstone914@aol.com

If these will work with a 1974 2.0, I’ll take them.
[/quote]

They do work with a 1974 2.0.

Bruce

Posted by: Highland Nov 30 2019, 09:39 PM

Are these thicker and stronger than the newly produced tubes?

I bought a "new" set and went back to my originals cause the new one were so easily crushed.

Posted by: bdstone914 Dec 2 2019, 06:41 PM

QUOTE(Highland @ Nov 30 2019, 09:39 PM)

Are these thicker and stronger than the newly produced tubes?

I bought a "new" set and went back to my originals cause the new one were so easily crushed.

What brand new ones did you buy ? Dansk ?

They are quite sturdy. I have knocked out the dents by forcing them onto a round manderal and they are not easily damaged.