Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WTB: 914 Parts _ more side shifter linkage parts

Posted by: brant Jun 30 2020, 02:57 PM

I just learned this shifter is missing a spacer.
so I'm selling the 3 pieces of linkage for $25 now.
buyer is welcomed to have the shifter, and indent plate if they want to have it.

New Price is $25 plus actual shipping costs to the buyers address.

brant

Please note. The shifter is missing the 2 springs. I used to run a weltmeister aftermarket heavier spring in this shifter. I don't know where I used the welt, springs when this was pulled from the car. I also had replaced the detent shift plate when this was in my old race car. So it has very little wear on the detent plate.

buyer would need to replace the 2 springs... stock/or heavy duty. The pins and hardware for the springs are intact.

also included are:
- a rear shift bar
- the bushing cup at the rear of the linkage
- and the front attachment at the base of the shifter
- shifter minus 2x springs

all of ~~these for $50 and~~ buyer pays shipping.
the length of the shift rod will add to the cost of shipping some
but shipping is ACTUAL shipping to your destination

Attached thumbnail(s)

Posted by: brant Jun 30 2020, 02:59 PM

and

Attached thumbnail(s)

Posted by: brant Jun 30 2020, 03:02 PM

and

Attached thumbnail(s)

Posted by: brant Jun 30 2020, 03:04 PM

and

Attached thumbnail(s)

Posted by: brant Jun 30 2020, 03:05 PM

and

Attached thumbnail(s)

Posted by: brant Jun 30 2020, 03:07 PM

and:

Attached thumbnail(s)

Posted by: ndfrigi Jun 30 2020, 03:19 PM

I will take it sir!

Posted by: brant Jun 30 2020, 03:24 PM

Sounds good
Pm coming

Posted by: bdstone914 Jun 30 2020, 06:52 PM

brant
' date='Jun 30 2020, 02:24 PM' post='2829632']
Sounds good
Pm coming
[/quote]

That shifter looks like the one that has a hardened bushing that inserts into the hole at the bottom which attaches the right angle part that clamps on the shift rod. They get lost.
The later side shift shifters had no bushing and an 8mm hole.

Posted by: brant Jul 1 2020, 07:10 AM

[quote name='bdstone914' date='Jun 30 2020, 06:52 PM' post='2829686']
brant
' date='Jun 30 2020, 02:24 PM' post='2829632']
Sounds good
Pm coming
[/quote]

That shifter looks like the one that has a hardened bushing that inserts into the hole at the bottom which attaches the right angle part that clamps on the shift rod. They get lost.
The later side shift shifters had no bushing and an 8mm hole.
[/quote]

Thank you Bruce
you have saved me again
I didn't realize this

I'll measure the shifter hole.
sounds like if it is large.. needing a spacer... then I'm missing that part.

and will adjust my ad right now.
brant