I'm looking for the brake line fittings that go into the master cylinder on the end of the reservoir lines.
Eric at PMB lists the plastic lines (for about $30), but my metal fittings at the bottom are corroded and the replacement porsche ones are v expensive from Stoddards/AA/Pelican etc
Looking for a clean set of used ones, or is anyone remaking them from the correct pipe??
They look like they're not too complex and simply have a flare fitting on the end that goes into the MC?
Thanks in advance Nick
=================================
PM sent.
Send me a picture or diagram
of what you need and if I have
some you can have them for a
grand total of $ 0.00 (just pay
shipping).
Thank you.
===============================
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)