an original, J-tube cap for the heater system
not cracked, clean condition
$6 shipped in the US
Attached thumbnail(s)
I just bought three of those.
Nice.
does the -6 use them?
I'll take it! PM incoming.
Can you get me the inside and outside diameter? Wondering if this will fit the backdated heat pipe off the fan shroud (drivers side)
They fit over the J tube that comes up through the engine tin from the heat ex changers. If you don't have a auxiliary electric fan, you use these to cap off the J tubes. So whatever size that J tube is, the inside diameter of the cap needs to fit over, and not necessarily snugly. They are typically fitted with a hose clamp, which is why they have two slots. Getting an accurate inner and outer dimension on a 50 year old plastic cap is a bit of a crap shoot, but...
2.13" inner (54.2 mm)
2.37" outer (60.3 mm)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)