Does anyone have a set of these flaps? The bigger one is mangled pretty bad and the smaller one is non existent.
Cheers ,
John
I believe 914Rubber. I just replaced mine. Pelican may have them as well.
Another issue is the used are almost always missing the seals that come on ours
https://914rubber.com/pressed-air-intake-flaps-wfoam
Also have the new pins for these too that are shown and included
Attached image(s)
May want a set of these too while you are there
https://914rubber.com/heater-blower-plate-gasket-kit
Attached image(s)
In all fairness you're not missing it we just keep making more stuff. WE can offer free shipping if we jack up the price, doing so means each part has to cover it's shipping. Then we would have to figure out how to no overcharge when you buy a bunch of stuff. It's not as easy as it looks as shipping is based on size not price of product.
It's easier and more transparent to just charge actual shipping.
Hope that makes sense
I believe we are talking about the same part. They replace the ones in the somewhat rectangular metal "caps" that bolt on. Most are missing altogether. These are reusable as they are a high temp silicone. Note we have also included the stainless allen screws so that you can actually get these off later if you so desire without stripping the cheeseheads that factory used.
Thanks for the reminder Mark, ordered both parts while our 2.0 is being rebuilt.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)