Printable Version of Topic

Posted by: Steve Jun 23 2021, 07:31 PM

I do not want to trash my factory 914-6 tin for my 3.6 project.
I need the front, sides and left rear piece that goes over the engine oil cooler.
I already have an aftermarket right rear piece
Anyone have any trasher pieces there not going to use?

Thanks
Steve

Posted by: mepstein Jun 23 2021, 08:48 PM

Ben might have something @http://www.914world.com/bbs2/index.php?showuser=9892

Posted by: Steve Jun 23 2021, 08:52 PM

Thanks, but I pinged him first. He said he is waiting for another supply of steel. Could be a couple of months. I am in no hurry...

Posted by: peteyd Jun 24 2021, 07:33 AM

@http://www.914world.com/bbs2/index.php?showuser=822

I have what you need here

https://www.restoration-design.com/store/SRCH?Search=pp320

Pete

Posted by: mepstein Jun 24 2021, 07:37 AM

Pete - I think the cheaper aftermarket tin might be a better choice since its easier to weld the needed extensions for the 3.6.

Posted by: Steve Jun 24 2021, 07:57 AM

Thanks Pete!!
Restoration design looks as good as the factory stuff I already have. I was hoping for the half price alternative that I can cut and weld the 3.6 pieces on.

Posted by: mb911 Jun 24 2021, 02:58 PM

I am out for sure until August but then spooling back up and will make 100 set's.

Posted by: Steve Jun 24 2021, 05:41 PM

Thanks @http://www.914world.com/bbs2/index.php?showuser=9892 aka Ben!! I might not be ready for them until August. Let me know when your shipping again!!

Posted by: mb911 Jun 25 2021, 09:51 AM

Will do.