I have a very clean gas tank. the pictures of the inside did not come out well, but I did use a flashlight and the interior is very clean with zero rust.
the outside is original finish, no holes, no wear through anywhere... still has a factory assembly stamp on it.
includes the sending unit, the bottom pipes and hardware, and cap that someone painted
it has no fuel smell and should be shippable...
but it will be a large package and oversized.
pick up obviously welcomed.
$100 + actual shipping cost
Attached image(s)
this is a dash face from a 1972
a good template for anyone recovering their dash$10 + actual shipping sold
Attached thumbnail(s)
This is the rubber lower portion of an 1980's flex dam.
it has some scrapes and scuffs. It also includes the mounting hardware.
Free to anyone that wants it
just pay the actual shipping.
and I think I can roll it up into a smaller box (not so long)
I wiped just the end down with simple green
did not clean the whole piece
but most of the bugs and dirt come right off
Attached thumbnail(s)
I think 914 rubber is reproducing these..
this is an original but shows some wear
Its the bump stop for the engine lid
I don't have the mounting hardware unfortunately
$5 plus actual shipping.
Attached thumbnail(s)
one complete set of engine cooling flaps.
with the spring, and with the black plastic bushings in good shape.
the linkage, and all$35 plus actual shipping. sold
Attached thumbnail(s)
Attached image(s)
and an incomplete engine cooling flap
missing the flap for the oil cooler (cylinder 3/4)
it does have the spring, and good useable plastic bushings$10 plus actual shipping sold
Attached thumbnail(s)
Attached image(s)
I'll take the complete flaps
PM Sent
I need the dash face
PM Sent
Great thank you so much
bump..
down to the small items
make me an offer if you can use any of them
Brant Ill take the incomplete cooling flaps
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)