Printable Version of Topic

Posted by: rcarson25 Oct 18 2021, 05:57 PM

Finally back on my 914 2056 project and looking to mount my new stock oil cooler. I am looking for the 3 studs that mount to the oil cooler to the block or at least need to know the sizes and also looking for the brackets that go on the left and right of the oils cooler. I believe these are needed to fit some of the other tins. Bonus points if already powder coated or painted black. .

Posted by: saigon71 Oct 19 2021, 06:03 AM

PM sent.

Posted by: rcarson25 Oct 25 2021, 06:49 PM

Still looking for number 5 in the diagram if anyone has one.


Attached image(s)

Posted by: Al Meredith Oct 26 2021, 01:12 PM

I've never seen the #5 , I do have the three studs if you still need them. AL

Posted by: rcarson25 Oct 26 2021, 05:32 PM

Thanks Al I got everything but #5. The fact that you have never used it makes me feel better about not having one.

Posted by: bkrantz Oct 26 2021, 08:39 PM

It goes here, bridging from the large cooler bracket to the blower housing. No where near the cooler studs.


Attached thumbnail(s)

Posted by: Al Meredith Oct 27 2021, 12:05 PM

OH! that #5. I went out and looked at about 12 oil coolers I have and found none have that piece on them. I looked at 2 1.8 engines and didn't find that bracket either. THEN I looked at a 1976 912E 2.0 engine and It had the #5 lower bracket. Maybe someone can comment on this . Seems to me that it was used on the 2.0 or it was used on later engines. AL