Looking for 1/2" phenolic spacers to go under the intake manifolds for my weber carbs for my /6.
The manifolds have 36mm holes going into the intake ports.
John
I would like to know where to get these as well!
Or know of a source that makes them.
http://pmocarb.com/
I bought a set from them years ago. They needed a little sanding on each side to get them to be flatter. Get your gaskets from them too. They are thicker than the stock ones. You'll need longer studs too. I can't remember, but it may be a complete kit.
I put a gasket on both sides of the phenolic so that doubles the number of gaskets needed to buy. OP talked about these being 1/2" thick but in reality it's probably closer to 3/16".
I was going to get a set from this place:
https://www.partsklassik.com/p-725-conversion-phenolic-insulator-kit.aspx
I got them from Partsclassic too.
Thanks for all the leads!
I will need longer studs too.
John
Youroil.net great guy works out of his home and truly appreciates the business
Ordered mine from Partsclassic
Hey John,
I have these from clewett.
Shane
https://www.clewett.com/index.php?main_page=product_info&cPath=4_48&products_id=330
I got a set from Larry at Youroil.net.
They were delivered today, which was super fast these days.
Great recommendation!
John
I ordered to Klassic parts, amongst other stuff such as cover gaskets and it’s taking longer than I anticipated. I have my powered coated engine parts ready to be torqued!
PMO kit comes with longer studs (which I needed), 12 gaskets, and new hardware.
All for around $70 shipped.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)