Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ FREE: 3D printed engine lid quick disconnect
Posted by: michael7810 Feb 3 2022, 01:47 PM
A member was making these years ago. I never tried to install it...someone here might have tried one and can comment. IIRC you don't have to modify the lid to use this. 
Posted by: ahycaramba Feb 3 2022, 02:11 PM
I’ll take it.
Thanks
Al
Posted by: vintagethunder Feb 3 2022, 02:12 PM
PM Sent!
Posted by: michael7810 Feb 3 2022, 06:40 PM
QUOTE(ahycaramba @ Feb 3 2022, 01:11 PM) 
I’ll take it.
Thanks
Al
Al - you are the winner. Check your PMs
Posted by: nditiz1 Feb 3 2022, 07:06 PM
Neat idea. I would be cautious though. If these were made with PLA the heat might not hold up to well in the engine compartment. Depends on how hot it gets in there. I made some directional vents for my 911 and found the heat started to warp them some I'm going to try PETG next.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)