Prefer to sell all together
Harness is a 1970 914-6. This was removed recently and was cut cleanly at center tunnel. Was pulled from a long time race car and cannot speak to continuity for any wire definitively. There were a few wires in the dash that also melted after PO had removed some gauges and did not isolate the wires properly. Ignition circuit was definitely modified to a dedicated push button start. Light switch is still connected presumably properly and probably works. Last used early 2000s for a night race at Sebring. Pulled wires from the headlights all the way to the brakes.
Wiper and turn signal switches also included. Wiper switch definitely worked but cannot speak to turn signal operation. Has not had turn signal buckets since mid 80s. Would expect it works but not sure.
Not selling the circuit board as yet.
$400
Comes with three gauges as well as the fuse box. Appears to have some of the engine harness as well but cannot be definitive on that either.
Attached thumbnail(s)
Or Best Offer. Feel free to insult or educate me
Updated to $400 for everything.
$300
Could you post some pics of the TS and wiper switches?
Pending payment
Sold
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)