Printable Version of Topic

Posted by: TJB/914 May 17 2022, 05:38 PM

Selling D-Jet parts assembly to complete your F.I project on 2L motors.
The (2) runners (3) hole D-Jet with a clamp has been powder coated to factory correct color and the flange face machined flat & true. The assemble box is in excellent condition and needs factory color touch ups.

These 2L parts are off a mint 1974 and fit 73-76 D-Jet motors. Good D-Jet stuff is getting difficult to source & prices will increase, sadly

Price: $250.00 shipping Included anywhere USA


Tom
Michigan


Attached thumbnail(s)


Attached image(s)

Posted by: TJB/914 May 20 2022, 02:12 PM

Bump

Just pointing out a CW notes of interest.
Look at the throttle bracket showing at the right on the air plenum, it's a wider bracket in 1974 since 1973 brackets were narrow & weak.
I assume 75 & 76 were the same. Ask Jeff B
FYI: D-Jet stuff is getting hard to source.

Tom

Posted by: JamesM May 20 2022, 03:25 PM

73-74 used the same setup, 75-76 had a different plenum with a different port configuration and the wide throttle cable support.

What you have here appears to be for 75+ cars based on the bracket width. Check the ports on the side though, 73-74 had two larger ports where as 75+ have one large and one smaller.

Posted by: TJB/914 May 20 2022, 06:27 PM

JamesM

You are correct except the larger bracket was updated mid or later 1974's. The came off a mid year 1974 so it probably carried through 1976.
Photo of the (2) side ports.
Tom


Attached image(s)

Posted by: TJB/914 Jun 1 2022, 06:32 PM

New Price and added (2) fuel lines & (4) F.I. holders

Price: $250 plus shipping anywhere USA (or best offer?)
Est. shipping less than $40 max.


Attached thumbnail(s)

Posted by: TJB/914 Jun 3 2022, 03:44 PM

BUMP

Before it goes back to storage