This was last summers test mule for me. It is a 1.5 stepped to 1.625 header set with single driver side heat exchanger setup. It was made based off of Pete stouts theory of sufficient heat along with some weight and cost savings. Headers from me are NLA at this time. I have stuff in the works but out a ways. The heat worked fantastic and I am In Wisconsin. Asking 2200 obo and will consider trades of headers, stock heat exchangers in need of repair/rebuild.
Thanks for all the support over the years I really appreciate it.
You guys already know the quality of Ben's work. If I did not already have Ben's full (beautiful) exhaust on my car I would snap these up just because they are that good.
If I didn’t already have two sets of Ben’s HE’s, I’d buy them.
Pending.
Hello,
Did they sell?
Thank you,
Jamie
Gosh yes long ago
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)