I have 66mm studs on the car, but have too much stick out (15mm). Anybody sitting on 10 (just doing the rear) studs in the 50-55mm range?
Check around. Studs are M14 x 1.5. Should be some universal fits out there. Check SwayAway.com
Curious;
You will need to remove the hubs to press these out? Can this be done without damaging the bearing?
Aaron, I think I may have some in a set of 911 front hubs, that I wanted to replace with longer, I'll double check the length. Is your issue 'visual' or something else (hard to change wheels or something else?)?
.
Bump! Still hoping to find some shorter (used) studs. 45mm fronts are too short FWIW.
here is the tool i made to http://www.914world.com/bbs2/index.php?s=&showtopic=91491&view=findpost&p=1550806 from the rear hubs
Last fall I was looking for 50/55 studs
looked everywhere... but ended up buying brand new from a race shop due to lack of availability....
just looked through my receipts but couldn't find the seller I used.
its a not common size it turns out.
brant
Think this may work...
https://www.ecstuning.com/b-h-and-r-parts/m-14x15-x-55mm-wheel-spacer-stud-priced-each/14555164/
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)