Selling at $35 per set shipped.. Only 9 sets available. Will be here by end of week. Payment then.
Attached thumbnail(s)
I would, but my current VW blades are 10 1/4”.
Mark - are these the ones for 914s? If so, I'll take a pair.
914 Factory Blades are 13"
I am in for 2 sets (4 blades)
3 sets spoken for
Mark,
Are thise the 7mm wide arms that fit the originals or 9mm fir the replacement arms?
Should know by Wed, Thurs.
thanks Mark!
I’m in for a pair if they fit my arms.
Also interested if they fit the stomach arms. Thanks!
Steve
Blades are in and correct. They fit the 914 arm correctly. Plastic clip has 6 lock points to hold 914 wiper arm in. Going to take wipers out of boxes and install correct clip so there is not any confusion on what to use.
Attached image(s)
Mark id like to confirm my desire to purchase a set
Brant
Yep, still interested.
Please add me to the list for one set. Thank you.
I had to change the price to $35 because I had to purchase oversize envelope to ship these in. IF you wish to decline I understand.
Attached image(s)
2 sets please.
Sold out at this point. If someone backs out I will make the set available
Pending buyers
2 treemn
2 rfinegan Paid
1 dreem Paid
1 starbear Paid
1 scallyK9 Paid
1 strarfink Paid
1 bryant Paid
PP: a914nut@email.com $35 shipped
Treemn 2 sets Shipped
rfinegan 2 sets Shipped
dreem 1 set
starfink 1 set Shipped
your shipment are ready to go
Paypal: a914nut@email.com $35 per set
PP Sent
Payment sent.
Thanks Mark!
Payment sent, along with gas cap payment combined.
Payment and address sent (from wife’s PayPal).
Thanks Mark!
All sold and shipped
Thanks Mark,
packaged arrived safely !
brant
Hi Mark,
If the last one gets available Ill take it.
Thanks
Just updated. All sold and shipped.
Mine arrived today...some one at the post office must have been curious of the contents, as my envelope was open. A rubber band kept the contents in place. Inspection shows they were not interested and blades
arrived safely
Guessing I am going to have to add tape on seals.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)