I tried searching but alas……does anyone have measurements/reference for placement of replacement rear trunk hinge pivots? I’ve got 2 new repo hinge pivots to weld in but the previous pivots were such a mess I don’t really have any references.
Posted this in the wrong place. Admin please remove.
I went thru this recently too, but the engine was out of my car so I was able to mount the trunk lid and hinges, and work from inside the engine compartment making the bracket placement obvious.
If that’s not your situation, I bet you could make a template out of card stock, from the side that is still firmly mounted….where the edges of the template butt up against the top edge and rear edge of the general area and a “cut out” where it’s pivot bracket goes - then invert the template you’ve made to determine exact placement on the other side of the engine compartment. Apologies for the over explanation.
.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)