Getting a 76 road worthy in Cali so I need a smog pump and all the tubes etc..
Let me know what you have.
Thanks
I’ve got the pump and hard lines
Will get some photos for you
lots of pictures
Attached image(s)
Boy, am I glad I don't have to use that stuff on my 75 Federal spec car...
That is the first time I've seen ND (Nippon Denso) and Bosch share a parts sticker.
Proves the OEMs will sleep with anyone...
That will be a rotary vane pump.
I'd take that apart, grease the bearings and clean up the cases and the internal parts before I put that back into service.
Parts for that pump might be "hen's teeth" to acquire. The bearings will be able to be purchased from a bearing supply using the numbers on the bearings/seals.
It may be me looking at this, but the sacrificial rubber part looks like it's broken on this part
I had a 76 car and when the pump froze it broke this sacrificial rubber part this is the part that connects to the crank. If I'm remembering correctly the part has a metal plate on the end where you bolt up the 3 bolts.
Best Bob B
I think I might be able to get away without adding this stuff. Stand by.
I believe I have most of the stuff, gotta start pulling it out. My spider is good, I remember losing one on my 76 bus and it was impossible to locate one 30yrs ago
I have a 75 CA Spec and need the sample pipe that runs from the egr valve you have pictured with the square flange to the muffler area port. Its sort of L shaped, has a welded tab to bolt it to muffler, and 2 bolt square ports at each end. Any help anyone?
Thanks, George
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)