Printable Version of Topic

Posted by: Puebloswatcop Dec 3 2023, 05:39 PM

I am checking to see if anybody might have some spare harness clips for the relay board. The part number is 914 610 107 00 and its #16 in the parts diagram. So many of these are lost or thrown away, just like mine. Any help is appreciated.

Posted by: DennisV Dec 3 2023, 06:29 PM

I assume they are NLA? Ping me in a couple weeks if you come up short. It looks like our car has one. I could take some dimensions and probably 3D print one. It obviously won't be original, but should be functional (i.e., ABS plastic).

Posted by: Puebloswatcop Dec 3 2023, 06:35 PM

You guessed it NLA. How much do you think it would cost to 3D print them?

Posted by: 914Sixer Dec 3 2023, 09:21 PM

Check with Bruce Stone. He said something to me about 3D printing them last month.

Posted by: Puebloswatcop Dec 4 2023, 08:37 AM

I will, thanks Mark

Posted by: DennisV Dec 4 2023, 09:28 AM

Based on the current price of ABS filament, I estimate $.24 in material cost. My time however is priceless.

I'm not trying to make money. Just offering to help. It looks like I have one on my car. I will be back with it end of December and can get dimensions.

Please update if you find a source. Otherwise I should be able to help if you can wait a few weeks.

Where is the 3D printing Smilies?

Posted by: majkos1 Dec 4 2023, 09:53 AM

this helps?

Posted by: DennisV Dec 4 2023, 02:33 PM

Thanks, but I don't think I can do a decent job unless I can get my calipers on one. Then compare my print to original side-by-side.

Posted by: 914Sixer Dec 4 2023, 03:39 PM

Thinking I sent Bruce the last ones I had but I will check and see IF I can donate some to the cause.

Posted by: Puebloswatcop Dec 4 2023, 05:45 PM

Thanks for everyones help on these. I know that there should be a market for these as I know many have been lost, or maybe aren't even installed on many cars.

Dennis V, this is as close as I can get to 3D printing smiles

Posted by: Puebloswatcop Dec 4 2023, 05:46 PM

I'm not in a huge hurry, so I will wait patiently.....Thanks

Posted by: bdstone914 Dec 4 2023, 07:56 PM

We have made a good prototype going to have them made in China,

Posted by: DennisV Dec 31 2023, 12:42 PM

As promised, I took a run at this. Here's my NYE morning's worth of productivity. If you PM me your mailing address (assuming US), I will print a couple in black and send them to you. You may want to do a little sanding to remove the support material from the edges. I just pulled this off the printer.

Posted by: 914werke Dec 31 2023, 03:15 PM

nice!