Printable Version of Topic

Posted by: chunger Feb 22 2009, 02:51 AM

I have some suspension and brake parts I need to get rid of that were originally intended for a V8 project. . . I guess I'll post the rear bits first. If you like the parts but don't like the price listed, post up and I'll adjust. I haven't looked at this project for a few years and have not had my finger on the current price trends.

Koni adjustable coilover shocks w/ adjustable perches, 195lb. springs. These are brand new and have never been installed. $400 SOLD

911 25 spline spindles, hubs, and heavy duty bearings (was for 5 lug conversion to 930 tranny) $130 SOLD

914-6 brake rotors pair new marked "Sebro 5184 Made in Germany" $150 (prices has been dropped because Eric Shea informed me that the street price for these is $200) SOLD



Good set of trailing arms that have not been cleaned up. Figured if you're doing a 5 lug conversion, it might be nice to be able to prep a set and pretty 'em up without taking the old ones out. I removed the wheel bearing from these w/ the proper tool. $25
(Note: bolts have been sold separately, trailing arms still available w/ reduced price)



For the front side, I have 911 boge M-struts, Girling 4 piston calipers adapted from Volvo 240 sedan, Colman vented rotors. New bearings. This setup is fresh and never been run. The coleman rotor re-order part number is L81-110-150 and specs for them are:
- .905 thick
- 12" OD
- 6.385 flange
- 8" eye
- 8 holes
- 7" bolt center
- 8mm x .125 pitch hole threads (fine thread)

$550

Koni Red adjustable inserts new. [s]$350 SOLD $320 after Lavanaut brought this to my attention: http://www.paragon-products.com/product_p/...-8641-1077s.htm



Sway-a-way 22mm solid torsion bars new (914 spline) $200 SOLD

pair good used ball joints $50 SOLD





I also have a stock front swaybar w/ drop links and bushings -$100
SOLD

Posted by: slow914 Feb 22 2009, 03:14 AM

PM Sent

Posted by: jrthomasec Feb 22 2009, 11:21 AM

PM sent for sway bar

Posted by: MikeSpraggi Feb 22 2009, 11:41 PM

PM sent on the torsion bars.

Posted by: Lavanaut Feb 23 2009, 11:48 AM

PM Sent on Konis

Posted by: computers4kids Feb 23 2009, 07:43 PM

Posted by: Lavanaut Feb 26 2009, 06:40 PM

Parts showed up super-fast, well packed, reasonably priced...thanks 'Chung!

Here's a bump for ya...

Posted by: MikeSpraggi Feb 26 2009, 07:17 PM

Paypal sent for torsion bars.

Posted by: chunger Feb 26 2009, 07:27 PM

They went out today UPS. Tracking info should have been emailed to your paypal email account. These will not get to you as quickly as the other parts did for lavanaut (UPS ground is sometimes very fast on the west coast).

Posted by: 914ssw Feb 26 2009, 08:03 PM

Sent you a PM

Posted by: charliew Mar 24 2009, 12:36 PM

sent you a pm