I need a manifold pressure sensor for a 1.7. The part number ends in "49" Ideally it has been tested to hold 15 to 20 pounds of pressure for 1 minute. I found one for $175 that is rebuilt. I'm just trying to save some $$.
Thanks!
I have a rebuilt one that I will take $125 shipped.
If you stil need one, let me know. Just pulled one off my 73. I'll have to see if it will hold vaccum for one minute. Worked ok on the car.
I just got one off a 72' 1.7L. Will have to check to see if part # matches and the adjustment screw is still sealed by the factory wax seal. Also how do i test the MPS again?
I got my hands on a good one!
A vacuum pressure tester is used to test it. It's a handheld pump with a guage.
Shane
I have one with the seal intact.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)