Printable Version of Topic

Posted by: Britain Smith Sep 7 2009, 11:08 PM

I have a set of Pauter Roller Rockers that I had on my engine on the dyno only. They are 1:1.48 ratio and have needle bearing. These were new when installed and ran for less than a hour on the dyno. I went with a different set-up and now have these available. One rocker on each set was machined ~0.030" for clearance due to oversized spring retainers. These run ~$500 new, selling for $350 shipped. They are boxed up and ready to go.

-Britain

SOLD!