I just installed some MSD ignition wires on my type IV. My engine also has a Mallory dist. I recall reading somewhere that they are not a good combination. Something about the dist. not liking those wires for some reason. Anybody hear of this being a problem?
Cheers, Elliot
Elliot, I just pulled my Mallory Unilite paperwork out and it suggests using only "suppression type" "spiral core wires". Hope that helps.
Mike
It's the solid wires that are a problem. Spiral wound wires are what Mallory has always specified on their website. Following this is critical with the newer Mallory's. If your MSD wires are spiral wound they should be fine.
Um, if you just installed them, what was written on the package they came in?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)