Can someone post a simple diagram of the wiring on both rear taillight housings? I just need to plug them in and factory schematics give me the hives.
TIA
Eric - I might have exactly what you need. I was just (yesterday!) rummaging through the junk in my door pocket and found the hand drawn one I made. I'll go see if it's still there. Can I fax it to you?
From Jeff Bowlsby's site http://bowlsby.net/914/Classic/TechNotebook.htm
Eric - notes might not fax clearly .. hope this helps
light housing has five male connections, two over three
Left side (from center of car to left):
Two: Black/Green - 2 Brown
Three: Brown/black stripe - 2 thick black - Tan/Red Stripe
Right side (From Center of car to right:
Two: Brown - Black/Green
Three: Tan/Brown Stripe - 1 thick black - Tan/Red Stripe
[in both, the 2 brown line up over the Tan/Red Stripe pins]
Hope this gets you reasonably close... these were rough notes not a wiring diagram
{ I didn't see Doug's reply before I posted.. how close was I?}
Eric,
Here's a couple of pics I took on the Turd;
Left Tailight
Right Tailight
Perfect...
Thanks everyone.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)