Printable Version of Topic

Posted by: dlestep Nov 28 2009, 07:36 PM

I have sets left over from the initial run...shipping is free in CONUS.



I can repost instructions if you like.
PM me. I keep all personal information private.
Dave

Posted by: smontanaro Nov 29 2009, 08:56 AM

How do I know if I need this?

Posted by: dlestep Nov 29 2009, 09:36 AM

If your headlights sit crooked, it may just need adjustment on the outboard and
inboard support tube brackets. The major reason is if there is movement in the assembly when driving, causing "jittering headlights."
When your headlights are up, and your grab the upper edge and can feel movement, the bushings on the push rod are worn, and/or the pivot pin is loose or bushings are funky. I replaced everything in mine to remove all play in the system.
Remember that the acetal resin bushings in your car are 30+ years old.
The new pivot pins have a larger thread and boss than the original pivot pin. If the pivot pin has or had loosened, the failure mode is that the area of the thread relief cracks or fails and that light would not sit flush, and when up have a lot of play.

Posted by: dlestep Nov 29 2009, 03:00 PM

I could post the instructions again, if you want to go through them to determine things.

Posted by: pjhaun Nov 29 2009, 06:49 PM

How many sets do you have?

Thank You!!!!
Phillip J. Haun
Oak Harbor, WA.

Posted by: dlestep Nov 29 2009, 07:09 PM

...I have six sets left.....one set per car
I take paypal at 914dlestep@gmail.com

Posted by: dlestep Nov 29 2009, 08:08 PM

...I wasn't implying that you had to buy all six sets....Ha !
If you need one, buy one...Dave