use a socket (female) to cover the threaded portion (male)
i hope you get the idea of what goes where?!?!?!
another benifit of the socket is if the stroke of your press is too short, an extension will fit on the socket........
I did this the other day with Patrick and it was very easy!
Jeff
Attached image(s)
Oops sorry guys.....I was talking about the A -arms
Same thing. Use a large junk/elcheapo socket that fits the inner round area. Press on it. The fronts come out REAL easy on the press.
B
Ok will do. Looks like who ever pressed on the present bushings did so without grease as the rear bushes appear "bunched up" and the outer bearing wont push in enough (even on the press 500psi).
This means the front two bolt holes won't line up -Hence the replacement. I hope the poly bushings aren't too harsh.
Attached image(s)
Yes, don't do what Jeffs9146 did and wear sandals.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)