914World.com [Powered by Invision Power Board]

Posted by: koozy Feb 1 2010, 04:45 PM

I just had to post my experience with Eric at PMB.

Fantastic service and top notch products. I had an issue with calipers I got from someone else. Went to put them on and saw they needed to be machined on the ears to work properly. Crud... These are for a race car so the best is all I could want for the brakes. Called Eric and he said he had a set fresh from plating and he would rebuild them "right now" and send them out in the morning. BTW: This was after 8pm my time and later in his neck of the woods. Later on in the evening I found that I misplaced the pad springs for the rears and sent him an email or left a message on the voicemail (can't remember which). I figured it was a bit late for the springs to get sent so I wrote that part off. Just got a set of front M calipers from the mailman and low and behold... rear pad springs in the box... freshly rebuilt calipers, better than stock pistons.. etc... I can go on but it would sound like I have a crush on Eric, sooooo....

A big "THANK YOU"

You want the best??? Go with http://www.pmbperformance.com/home.html.

Mike

Posted by: McMark Feb 1 2010, 04:51 PM

Posted by: ConeDodger Feb 1 2010, 04:57 PM

QUOTE(koozy @ Feb 1 2010, 02:45 PM)

I just had to post my experience with Eric at PMB.

Fantastic service and top notch products. I had an issue with calipers I got from someone else. Went to put them on and saw they needed to be machined on the ears to work properly. Crud... These are for a race car so the best is all I could want for the brakes. Called Eric and he said he had a set fresh from plating and he would rebuild them "right now" and send them out in the morning. BTW: This was after 8pm my time and later in his neck of the woods. Later on in the evening I found that I misplaced the pad springs for the rears and sent him an email or left a message on the voicemail (can't remember which). I figured it was a bit late for the springs to get sent so I wrote that part off. Just got a set of front M calipers from the mailman and low and behold... rear pad springs in the box... freshly rebuilt calipers, better than stock pistons.. etc... I can go on but it would sound like I have a crush on Eric, sooooo....

A big "THANK YOU"

You want the best??? Go with http://www.pmbperformance.com/home.html.

Mike

You too??? I just have the biggest crush on him

Anyone else needing PMB rebuilt M calipers - I have a set I bought from Eric and did not use. I used the aluminum Brembos instead. PM me...

Posted by: turnaround89 Feb 1 2010, 05:43 PM

You want the best??? Go with PMB.

Posted by: wertygrog Feb 1 2010, 08:49 PM

Agreed!!

Posted by: 6freak Feb 1 2010, 10:45 PM

I can stop 2 P now

Printable Version of Topic