Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Engine bay seal

Posted by: jeffdon Apr 9 2010, 11:35 AM

See attached....I believe the correct installation is with the V (red line) facing up, so that the downward bent flange on the tin will rest in this V. Am I correct?

Attached Image

Posted by: realred914 Apr 9 2010, 11:44 AM

QUOTE(jeffdon @ Apr 9 2010, 10:35 AM)

See attached....I believe the correct installation is with the V (red line) facing up, so that the downward bent flange on the tin will rest in this V. Am I correct?

exactly as you said, Vee down is it!!!!!!

remember to use a big staple or a bit of bailing wire to tie off the two front most corners (the side pieces to the front peice) the factory had a big staple thru them to finish off the seal nice and tight.

Posted by: Mikey914 Apr 10 2010, 03:03 PM

You are correct. The V is down.