Printable Version of Topic

Posted by: bandjoey Apr 9 2010, 10:45 PM

I'm going to get a set of vertical window seals from Mikey but he only sells the rubber seal and I have to find my own top plugs for the seals. The tops on my car are beat up and worthless. His are $26 vs $125. I can make a plug from RTV for that much difference, but I'd like to find a pair in good condition if not new.

Anyone have a source of that top plug? Thanks

Posted by: Mikey914 Apr 10 2010, 12:48 AM

The can be cut from the old seals, but I do have these in the works, 4-6 weeks out. You can cut the extrusions and seal with silicone. But I will have this addressed very soon.

Tahnks,
Mark

Posted by: dr914@autoatlanta.com Apr 10 2010, 08:03 AM

QUOTE(bandjoey @ Apr 9 2010, 09:45 PM)

Posted by: bandjoey Apr 10 2010, 09:49 AM

Will the plug be a separate piece to glue on or molded on? I.e. Do I get the existing seal now and wait for the plug or wait for thecomplete seal?
Thanks Mark

Posted by: Mikey914 Apr 10 2010, 11:11 PM

My plug will be long enough that you could retrofit the extrusions that have already been purchased. Even those that have been cut and plugged. The idea is that I needed to have made these and that way you'll be able to have the correct fit. These will be able to be glued on and have a small "plug" that will extend into the extrusion to orientate it correctly

These will be about $11 a set. I just need to finish a few other projects I have started to tool up on these.

-Mark