I am trying to take off this extension for my carb linkage and I can't see a way to get this off. I don't see a nut down the center of it.
Any thoughts?
It may be attached to the butterfly. You may need to remove the entire shaft to get it out.
I got it...it was a weird nut of some type. Looked like a socket...was able to get a wide flat head screwdriver in there.
Now onto test fitting the bell crank linkage!
Attached image(s)
a big hammer
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)