does someone here make the windshield seal between the window and the dash with the clip in the middle?
I need the material for top of dash also the foam and this seal...
thanks guys
Mikey
914rubber.com
vendor section or multiple posts herein the garage. He's the rubber king.
Check the vendor's section of the forums , Mikey914 ( Mark ) sells all kinds of quality rubber seal replacments, he has this one also , send him an email to check if he has one in stock . Also look around your teener , there may be other seals you could use , he probably has those too . The dash stuff get from morph , he's in the vendors section also. God luck ....
Jack / jaxdream
That's the way I made mine, without the steel clip. I was planning to put the aliminum in, but after plating aound with it found it would be a big pain in the butt to install with the clip. That way it can install without removing the windshield. There's a thread I did on this about a year ago.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)