I have an LX91 (model # fixed, thanks mcmark) ignition coil. The plug wires in my car need to be replaced, so I bought the stock bosch set from PP.
The connector on the coil --> dizzy wire doesn't fit over the contact nub in on the LX91.
Does anyone know what wires will fit properly? Should I get a set of magenores?
Looks something like this:
Attached image(s)
Yup, stock center lead won't work. Stock wires are meant to slide into a tube. You need the style that go around the pin.
You can get the supplies to make your own at most FLAPS. I got mine at NAPA. I can make a cable for you if you can't find anything else.
Can't tell you off the top of my head what would work though. Too many combinations out there.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)