I have checked relays and fuses- all look fine, front fans will not turn on for defrost/fresh air . any suggestions?
Phil w.
If you have to open it up, let me know. I have the seals for the little flappers and the center of the main body. I also have the rubber edges for the early style.
Check that the HVAC controls are all working right. The fan traces on mine are all work out and work intermittently even after I cleaned them up.
I had this problem too and just cleaned it up and the contacts and it started working again amazingly, try that and see if it works...now the lights on my heater control panels are blown out so I am going to pull that out sometime soon. Good luck
Jamie
Its like every thing else on the 914, a pain in the ass. Wear leather gloves, there's a lot of sharp edges, and the control wires will stab you given half a chance. There just is no easy way.
Pull hood, pull gas tank, disconnect control cables, pull dash control, and while you're in there, clean and paint the gas tank cavity, paint the tank, it never ends.
Good Luck
One other thing to check: There are three wires with small spade connectors on the right side of the control unit. I found mine unconnected due to sloppy radio installation. The installer knocked the wires off the connectors. I pulled the radio as well as the din ( cage the radio locks into ); look for the three spades and wires on your left.
thanks Jim. hopefully it's something simple.
I replace the OEM fuse panel with Jwest's just now, and I noticed that one of my relay slots is missing the relay. are all of them supposed to be populated with relays?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)