I'm rebuilding a set of Dellorto DRLA 40's. I bought new throttle shafts or sindles as well as new spindle bearings and butterfly vavles. I'm having a very hard time getting the bearings pressed in the carb body and on the shaft, all well keeing it lined u for the valves to go in. I've already wrecked one new shaft, and may have wrecked the other. They're not chea so before I go ahead and attemt this with 2 new shafts I'd love some tips.
Thanks and tara!
In the CB Dellorto overhaul manual, it states not to take the bearings and shafts out for an overhaul, or 'you'll have to go to a VW Bug shop since they have the special tools for installation'.
I've never taken my carbs that far down but I can see why now. Hopefully someone here has the "special tools" needed you can loan out or find a local shop to install them for you.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)