On the two from the 914/6 oil tank and the oil line coming off the block? My mind is fading in my old age....BTW....I will be cutting the one coming off the engine cooler and soldering on a 90 to clear the swing arm...
Are they (2) 30mm and (1) 26mm with a 1.5 pitch?
I am looking at BAT in Florida that carries the XRP conversion fittings.....to -12AN.....looks like HPH is having a hard time getting them from their supplier....
Also....do any of them need a 45 or 90 bend? Been ahwile since I had to plumb one of these....
Also...anyone have an oil console, cap, dipstick and filler neck? Early 911 stuff works....so if ya have an old crappy tank laying around.....
Pegasus sells the adapters...
Are you just looking for the -AN to metric adapters?
If so I have an unused male and female set...
Oh yea I have and early 911 ('70) console, and filler neck.. Im sure I can scrounge the dipstick up
I have the early 911 oil tank but it has "impact" damage LOL
Yeah....need any 914 parts in trade?
Here's the fittings I have used in the past...
http://www.batinc.net/files/ahosend.pdf
Email me please.... 356@cox.net
Send me your telephone # and I will call ya....
Thanks
Still need the fitting sizes....
Anyone???
Bueller?
Ferris Bueller?
sheesh
30mmx1.5mm to either -12 or -16
That I know....but are they ALL that size? I thought one was a 26mm.....
The tank and engine are at the garage....won't see them until next week.....Easter, kids and work,,,,,
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)